Octagon 6000 Series, User Manual

Page: 113 / 233

11-4
Video 6000 Series user’s manual
Failed to receive <drive>filename.ext!
Deleting <drive>filename.ext
Also, you may speed up the transfer using the /Bnnnn switch to increase
the baud rate, for example, /B57600.
Using REMDISK/REMSERV
1. Connect the equipment as shown in Figure 11-1.
2. On the PC Microcontroller system, execute REMDISK.EXE by entering:
60xx C:\> REMDISK
The following message is displayed on the PC Microcontroller monitor:
Remote Disk v1.0
Copyright (c) 1990-1994 Datalight, Inc.
All rights reserved.
Installed as Drive F: /COM1 /B115+ /T10
Note REMDISK assigns the remote drive as the last drive in the system. In
this case, drive F: was assigned.
3. Execute REMSERV.EXE on the desktop PC:
C:\> REMSERV C:
The following message is displayed on the PC:
REMSERV v1.0
Copyright (c) 1990-1994 Datalight, Inc.
All rights reserved.
Using COM1 at 115+ baud. Accessing Drive C:
Time-out is 9 seconds
Press <Esc> to Exit.(There may be a delay before exit
occurs)
4. Files are transferred to the PC Microcontroller read/write drives by
using the DOS COPY or XCOPY commands. From the PC Microcontrol-
ler system, enter:
60xx C:\> COPY F:\MPC\60xx\DEMO.EXE D:
60xx C:\> DIR D:
60xx C:\> D:DEMO.EXE
The DEMO program displays a message on the PC Microcontroller
monitor.
In this case, drive F: is the remote PC disk drive, and D: is the read/
write SSD flash memory on the PC Microcontroller. Files are easily
copied between the drives.
5. When finished, on the PC Microcontroller, execute:
60xx C:\> REMDISK /U
This unloads REMDISK from the PC Microcontroller.
6. On the desktop PC, press <ESC> to exit REMSERV.