Octagon 6000 Series, User Manual

Page: 40 / 233

3-3
6000 Series user’s manual Setup programs
Running SETUP
1. Make sure you have established a serial communications console I/O
link between the PC Microcontroller and your PC. Refer to the Quick
start chapter for more information on establishing communications with
your PC Microcontroller.
2. Enter:
60xx C:\> SETUP
Note You may also enter SETUP after the memory test and before the sys-
tem has booted by pressing the “backspace” key followed by the “S” key.
3. The system will display the PC Microcontroller setup parameters and
available options. Select the option by pressing the space bar until the
correct information appears, then press <ENTER>. Press <ESC> twice
if you want to exit setup without saving your responses.
Note Options having an * are default settings.
n
Serial Console on COM1:
Enabled*
Disabled
WARNING!
Disabling the serial console when there is no video card
present will stop further serial console communication with
the system after the system resets. Once disabled, you may
re-enable the serial console by running SETUP. To run
SETUP, choose one of the following methods:
n
Remove the USESETUP jumper, reboot, and run SETUP
n
Install a video card/monitor, reboot, and run SETUP.
(This method disables the serial console.)
n
COM1 Console Baud Rate:
1200
2400
4800
9600*
14400
19200
28800
38400
57600
115200
n
Power on memory test:
Enabled*
Disabled
You may want to disable the memory test to speed up the boot process.
You may also press the space bar to cancel the memory test while in
progress.