Oce TDS400, User Manual

Page: 59 / 210

Use the Océ TDS400 to copy 59
Stop a copy job
Press the ‘cancel’ button to interrupt the original transport.
▼
▼ ▼
▼
Stop a job
1
Press the ‘cancel’ button.
The original transport is stopped.
2
The message ‘Remove original’, ‘Press cancel’ appears on the scanner display.
3
Open the scanner cover and remove the original.
4
Close the cover.
5
Press the ‘cancel’ button. The message disappears on the scanner display.
Set synchro or standard cut
In synchro cut mode, the copy is cut at the length of the original. The length
depends on the zoom factor and the leading or trailing strip setting. The default
is Synchro cut mode.
In standard cut mode, the copy is cut at a standard format length (portrait). You
select the length of the standard format with the browse buttons.
Example: select 36 inches, means select a format of 36 inches width and a
corresponding 48 inches length. Independent of the roll width, the material is
cut at a length of 48 inches.
When you select standard cut, the system always cuts at the selected length. If
the original length is shorter or longer than the selected length, the cut is made
at the selected length.
▼ ▼ ▼ ▼
Select synchrone cut
1
Press the ‘extra’ button.
2
Select ‘Paper copy’ with the or button.
3
Press button, to enter the ‘Paper copy’ menu.
4
Select ‘cut length’ with the or button.
5
Press button, to enter the ‘cut length’ menu.
6
Select ‘on’ or ‘off’ with the or button.
7
Press the ‘confirm’ button.