Oce TDS400, User Manual

Page: 39 / 210

Use the Océ TDS400 to print 39
Error messages
Sensor not free
Remove paper
Press <on-line> The paper of one of the rolls is transferred after the marker (see
‘Feed the material’ on page 155) when power is applied to the
printer.
Take the paper back.
Press <on-line>
Paper retracted
Press <on-line>
Put the paper into the manual feed.
Press <on-line>
Copy too short
Remove paper
Press <on-line>
The length of the print material is less than 420 mm. This can oc-
cur with the manual feed.
Use an original longer than 420 mm.
Inputflap open
Close inputflap
The input flap is open.
Close the input flap.
Inputflap open
Remove paper
Press <on-line> The input flap is open during the print process
Remove the paper and press <on-line>.
Roll 1 empty
Open roll unit The paper on roll 1 is empty.
Open the roll unit and replace it.
Roll 2 empty
Open roll unit The paper on roll 2 is empty.
Open the roll unit and replace it.
Error messages
Error messages Explanation
Copy too late
Remove paper
Press <on-line>
The copy is too late at the paperpath output sensor
Remove the print material.
Speed failure
Remove paper
Press <on-line>
A paper jam occurred.
Remove the paper jam and press <on-line>
Knife 1 error
Remove paper
Press <on-line> An error occurred during the cut of the roll.
Check the paper in the roll unit and remove if necessary.
Press <on-line>.
Knife 2 error
Remove paper
Press <on-line> An error occurred during the cut of the roll.
Check the paper in the roll unit and remove if necessary.
Press <on-line>.
Roll retract err
Press <on-line>
Print material error when the roll unit takes back the material.
Status Messages (continued)
Status messages Explanation