Oce TDS400, User Manual

Page: 50 / 210

50 Océ TDS400 Digital Multifunctional System User Manual
Note:
The system is ready to use. You can turn ON and OFF the scanner
separate from the printer and without any particular order.
▼ ▼ ▼ ▼
Turn off the scanner
1
Set the on/off switch at the rear of the scanner, to position ‘0’ (see figure 9).
Start the copy process
If you press the ‘start’ button, and you do not change any settings, the settings
of the previous copy job are used or the default settings of the machine are
used:
■
number of copies 1
■
use roll 1
■
zoom 100%
■
synchro cut
■
no leading /trailing edge
■
auto exposure on; exposure setting 0.
Default settings are used in the following situations:
■
after turn on
■
after you press ‘cancel’ twice
■
after a time-out of 1 minute (since the end of previous copy job has expired).
If the ‘start’ button is pressed the original will be scanned. The original returns
to the operator if you have enabled the rewind function (see page 56). You can
make settings for the next job.
When the original returns, remove the original. A new original can be fed and
you can program new settings.
Make copies
The copying process starts when you press the ‘start’ button. Before you press
the ‘start’ button, you can change the settings.
▼
▼ ▼
▼
Feed the original
1
Insert the original face down and right aligned, along the original guide line on
the scanner feed table so that you can see the line (see figure 10).