Oce TDS400, User Manual

Page: 30 / 210

30 Océ TDS400 Digital Multifunctional System User Manual
Cut media
If the material does not have a straight leading edge, you can cut the material
at right angles from the roll.
▼
▼ ▼
▼
Cut the material from roll 1 or roll 2
1
Open the drawer.
2
Feed the paper manually until it is 5 cm above the top drawer.
3
Press the ‘on line’ button to put the printer off line.
4
Close the paper drawer.
5
Select the ‘Media settings’ item with the or button.
6
Press ‘next/select’ to enter the ‘Media settings’ menu.
7
Select ‘Cut media’ with the or button.
8
Press ‘next/select’ to cut the paper.
9
Open the paper drawer.
10
Remove the scrap of material.
11
Feed the material until you can see the material and put the material into
position ((see figure 57 on page 153) and 61 on page 155).
12
Close the drawer.
13
Press the ‘on line’ button to put the printer on line again.