Oce 5250, User Manual

Page: 140 / 198

140 Océ 5250 user manual
End of media error
(Error 25, 26) There is no media left. To recover, open the
dust cover, and install new media (see ‘Loading roll media’ on page 43). Close
the cover. Press the ‘Enter’ key to restart the media loading.
Media misaligned error
(Error 42) The media is skewed. To recover, open the
dust cover, and realign the media. Close the cover. Press the ‘Enter’ key to
restart the media loading (see ‘To align the media’ on page 47).
Media too small
(Error 38, 43, 44) The loaded media is too small to use the
automatic adjustment functions (minimum A3 size required). To recover, open
the dust cover, and release the green lever to remove the media. Replace with
the correct size media (see ‘Loading roll media’ on page 43). Close the cover.
Press the ‘Enter’ key to restart the media loading.
Carriage error
(Error 37) The printer engine has problems with the carriage.
To recover, press the ‘Enter’ key. Another possible cause can be a dirty guide
rail. Clean the carriage guide rails (see ‘To clean the interior of the printer’ on
page 129).
The following are possible hardware failures. These errors may require a
shutdown of the printer to recover:
Comm error
(Error 103) The communication between the engine and the
controller has failed. To recover, turn the power of the printer off and on. If the
error persists, contact technical support.
Carriage error
(Error 12, 17, 22, 23) The engine has carriage problems. To
recover, turn the power of the printer off and on. If the error persists, contact
technical support.
F/W update failed
(Error 47, 48, 49 and 102) The update of the firmware has
failed. To recover, turn the power of the printer off and on. If the error persists,
contact technical support.
F/W download failed
(Error 101) The printer received a wrong file. To recover,
turn the power of the printer off and on. Download the file again (see ‘To
download the firmware from the computer through the Centronics port’ on
page 94). If the error persists, contact technical support.
Auto-regi failed
(Error 39, 41) The automatic registration of the print heads
has failed, or the cover has opened during automatic registration. To recover,
turn the power of the printer off and on. If the error persists, contact technical
support.