Obihai OBi110, Administration Manual

Page: 136 / 202

Copyright 2010-2012 Obihai Technology, Inc. 136
LINE Port Parameter Guide:
Parameter Description Default Setting
LINE Port
Enable Enable the LINE port Yes
DigitMap Digit map to restrict numbers that can be dialed or
called on the PSTN line.
See
OBi Call Routing and Digit Map Section for a
description of the syntaxes for specifying a Digit
Map.
(xxxxxxxS4|1xxxxxxxxxx|xx.)
InboundCallRoute Routing rule for directing incoming calls on PSTN
line. The default rule is to send all incoming calls to
the PHONE port (ph).
See
OBi Call Routing and Digit Map Section for a
description of the syntaxes for specifying this
parameter
ph
RingDelay Delay in milliseconds after initial ring detected on
the LINE port before the device acts on the call (to
route it according to InboundCallRoute). This value
could be 0 so that the call is handled immediately.
However, you should consider setting it to a large
enough value to allow OBi to completely decode
the PSTN Caller-ID signal if the service is available
on the PSTN line. This is required if the
InboundCallRoute relies on Caller-ID information
to route the incoming call. 5500
RingProfile Select a Ring Profile to ring the PHONE port with
when an incoming call is routed to the PHONE
port. Choices are A, or B A
DefaultRing Default ring pattern number to ring the PHONE
port for incoming calls on this trunk that are
routed to the PHONE port according to the
InboundCallRoute of this service. The ring pattern
is taken from the selected Ring Profile. Valid
choices are 1-10 1
CallOnHoldRing Pattern to ring PHONE port when holding a call on
this trunk that has been connected to the PHONE
port. Typically this is a very short distinctive ring
pattern that serves as a reminder to the user that a
call is being on hold. The ring pattern is taken from
the selected Ring Profile. Valid choices are: NO
Ring, or 1-10 8
Tone Profile Select a tone profile for tone detection to support
the detection of outbound call connected state A
DetectOutboundConnectMethod Select a method to detect if an outbound call on
the PSTN line has been answered. It can be one of
the following values:
- None: Do not detect call connected state.
Device will simply assume the call is
connected once it finishes dialing
- Detect speech: Device will detect speech
signal on the line as a positive indication
of call connected state.
None