Obihai OBi110, Administration Manual

Page: 133 / 202

Copyright 2010-2012 Obihai Technology, Inc. 133
operation.
RepeatDialExpires Duration of time in seconds when a repeat dial operation
remains active. 1800
GenerateCPCSignal Controls when the device should generate a CPC signal
when the remote party hangs up on an established call.
The choices are:
- Never
- For Inbound Calls Only
- For Outbound Calls Only
- For Inbound and Outbound Calls
For Inbound and Outbound
Calls
EnableLINEPortBargeIn
1
This option is useful only when a PSTN line is connected
to the OBi110. By default a user can pick up the phone
and dial # to connect to the LINE port. If no one else using
the PSTN line at that time, the user will hear dial tone
from the phone company. On the other hand, if the line is
already in use, the user will hear fast busy tone if this
option is disabled, or join the current call in progress
otherwise.
This option is only available in OBi110. No
EnablePHONEPortBargeIn
3
Enable the caller to barge in when he calls the other
phone port from this phone port while the other phone
port has an active call in progress, on-hold, or ringing.
This option is only available in OBi110. Yes
EnableDoubleHookFlash A double hook flash event is two successive hook flash
events that are less than 700ms apart (by default). If this
event is enabled, the device will generate a hook flash
signal on the PSTN line if the phone is currently on a call
on the line. This option is useful only if
HookFlashHandling is set to “Handle Hook Flash Locally”.
This option is only available in OBi110. Yes
UseForPagingOnly Enables the OBi to be used for paging only when the
PHONE port is connected to an external PA system (via a
RJ11 to line out connector, available from many
electronics shops). In such configuration the PHONE port
is expected to be “off-hook” all the time; the OBi will
automatically answer an incoming call and will not accept
call-waiting. No
TransferWhenHolding This option provides a short cut to transfer a call to a fixed
pre-configured number without dialing it. If a valid
number is specified for this parameter, the OBi will
transfer the call to the given number when the phone
hook flashes and then on-hook (which would normally
leave the call holding if this parameter is not specified).
The valid number should be a complete number with
trunk information, such as SP1(14083334567).
MOHServiceNumber The number to call to get music streamed to the remote
party when the remote party is placed on hold
PlaySITOnCallFailureCodes A list of (3-digit) error response codes on outbound calls
to trigger SIT w/ optional announcement of the error. OBi
plays fast busy tone w/o any announcement for all other
call failure codes. The codes must be specified collectively ([4-9]xx)