Obihai OBi110, Administration Manual

Page: 129 / 202

Copyright 2010-2012 Obihai Technology, Inc. 129
SP1 Service ( code = sp1 )
SP2 Service ( code = sp2 )
SP3 Service ( code = sp3 )
SP4 Service ( code = sp4 )
OBiTALK Service ( code = pp1 )
PSTN Line ( code=li1 )
1
Trunk Group 1 (code=tg1)
The OBi device process the parameter by substituting of
the occurrences of
pli and (Mpli) in DigitMap,
OutboundCallRoute, and CallReturnDigitMaps with the
corresponding
code and (Mcode) . For example, if PrimaryLine = PSTN
Line , then all occurrences of pli and (Mpli) will be
substituted internally with li1 and (Mli1) respectively
ToneOnPrimaryServiceDown
(OBi202 and OBi302 only) Select the tone to play in place dial tone when the service
corresponding to the Primary Line is out-of-service.
Choose from:
- No Tone
- Normal Dial Tone
- SIT Tone 1
- SIT Tone 2
- SIT Tone 3
- SIT Tone 4
Normal Dial Tone
Ringer
RingFrequency Ringer frequency in Hz (14 - 68) to apply to the PHONE
port when ringing 20
RingVoltage Peak ringer voltage in volts (55 - 82) to apply to the
PHONE port when ringing 70
RingWaveform Ringer waveform to apply to the PHONE port when
ringing. Choices are Sinusoidal or Trapezoidal Sinusoidal
InterleavedRing
3
When both phone ports are ringing, enabling this option
will cause the OBi to interleave the ring signal applied to
each port to reduce the chance of overloading the power
supply. No
Port Settings
OnHookTipRingVoltage Tip/Ring Voltage when the attached phone is on hook (30
v to 52 v) 46
OffHookCurrentMax Maximum supported current (15 mA to 45 mA) when the
attached phone is off-hook 20
Impedance PHONE port impedance setting. Available choices are
(units in ohm if not specified):
- 600
- 900
- 270+(750||150 nF)
- 220+(820||120 nF)
- 370+(620||310 nF)
- 320+(1050||230 nF)
- 350+(1000||210 nF)
- 200+(680||100 nF)
- 600+2.16 uF
- 900+2.16 uF
600