Obihai OBi110, Administration Manual

Page: 125 / 202

Copyright 2010-2012 Obihai Technology, Inc. 125
OBiBlueTooth Device Settings Parameter Guide:
Parameter Description Default Setting
Discoverable Check this box and click the submit button to make the
OBiBT device discoverable for the next 120 seconds No
PreferredPairedDevice Select which paired device is preferred, in the event that
more than one paired device are in range. The value is
automatically set to the device that explicitly requested
connection with OBiBT None
PairedDevice N , N = 1, 2, …, 10 The name of the device that has successfully paired with
OBiBT
RemovePairedDevice N , N = 1, 2, …,
10
Check this box and click the submit button to remove
this paired device No
Phone Interface Features of the OBi Device
Repeat Dialing Service
Repeat dialing service is when a user dials *05 to tell the device to redial the last called number repeatedly while the phone
is on-hook, until the called party rings or answers. When that happens, device rings the PHONE port and the user can pick it
up to talk to the called party. Typically the last called number was busy when the user invokes this feature, but the device
allows this feature for all cases.
This feature can be controlled with the following two parameters (under the PHONE Port – Calling Feature section):
- RepeatDialInterval = the minimum number of seconds between each redial. Default is 30s.
- RepeatDialExpires = the maximum duration in seconds when the repeat dialing remains active. Default is 1800s.
User dials *06 to cancel Repeat Dialing. Only one repeat dial request is supported. Dialing *05 while a repeat dial is in
progress will be rejected with a fast busy tone. If *05 is accepted, the device plays normal dial tone.
Notes:
- The first redial happens 5s after the phone is on-hook following *05.
- When phone is off-hook or rings for an incoming call, device pauses redial and cancels the call if it’s already dialed
but the peer device is not ringing yet.
- As soon as phone goes on hook or ringing stops without any calls on hold, repeat dialing resumes in 5s.
- If called party answers before the local caller, device sends normal ringback tone over RTP to the called party.
- The ring for alerting local user when the called party rings or answers is taken from outgoing trunk’s
RepeatDialRing parameter.
- Repeat Dial service cannot be used on the LINE port. If the last call was made over the LINE port, dialing *05 will
result in fast busy.
- Repeat Dial calls are not logged to call history, except the last and successful one when the called party rings or
answers.