Nortel TDM Recorder, Installation Manual

Page: 21 / 128

September 2007 Recorder Hardware Installation
Installation Guide 21
2 Ensure that there is no possibility of static electricity shocks occurring.
Attention: An anti-static cuff or ESD wrist strap is strongly
recommended as a single static shock can destroy a voice card.
3 Turn off the power to the PC and remove all power cords before opening
the computer case.
Note: Do not re-attach power cords or turn on the power to the computer
while the computer case is removed.
4 Insert the card into an empty PCI slot in the PC using a chassis screw.
5 When secure, attach cables and turn on the PC.
6 Upon reboot, cancel out of the Found New Hardware window. When you
install the recorder software, the drivers for the Ai-Logix cards are also
installed.
Digital trunk side wiring
The following sections describe cabling and wiring for the Ai-Logix
SmartWorks DP voice cards, and provide typical wiring diagrams for T1
and E1 interfaces. This information is described in the following topics:
„
Cable lengths
„
Wiring for T1 and E1 interfaces
Digital
Trunk
Side DP3209
DP6409
Passive-tap recording voice cards capable of
recording 30 (DP3209) and 60 (DP6409) channels.
They are software switchable between E1 and T1.
See also: http://www.ai-logix.com.
Type Ai-Logix
Model Description