Nortel Passport 15000, Hardware Installation And Maintenance, Page: 468 / 874

468 Chapter 17 Hardware procedures
241-1501-240 5.2S2
Installing a kickplate
Install a kickplate to enclose the front or rear base of a NEBS 2000 frame.
Prerequisites
• You must be familiar with “Safety considerations and best practices”
(page 53).
• Use the kickplate that was installed on the frame at factory, as shown in
the figure “A standard kickplate on the base of a NEBS 2000 frame”
(page 469).
• You need a driver for
— the medium slotted captive screws that fasten the kickplate to the
base of the frame
— whatever fastener was used to connect the frame ground cable to the
kickplate or the kickplate extension
Procedure steps
1 Align the kickplate and screws to the base of the frame as shown in the
figure “A standard kickplate on the base of a NEBS 2000 frame”
(page 469).
2 If present, fasten the ground cable from the frame onto the kickplate.
3 Fasten the captive screws at the ends of the kickplate.