Nortel Passport 15000, Hardware Installation And Maintenance, Page: 426 / 874

426 Chapter 17 Hardware procedures
241-1501-240 5.2S2
Installing a door hinge onto the lower left of a frame
Install a door hinge onto the lower left front or rear of a NEBS 2000 frame to
enable opening a door.
Prerequisites
• You must be familiar with “Safety considerations and best practices”
(page 53).
• You need a door hinge from kit NTRU0192 as shown in the figure “A
lower door hinge P0884947” (page 412) and the lower left extension
bracket P0995494 that is the opposite of the figure “A lower right
extension bracket P0995493” (page 404). The lower left extension
bracket is already installed onto the base of the NEBS 2000 frame from
another procedure.
• You need 4 Pozidriv screws P0600060 and 4 lock washers P0600895
from kit NTPX4060as shown in the figure “Types of screws used with
frame enclosure hardware” (page 120).
Procedure steps
1 Align the holes of the hinge with the holes on the outside of the lower left
extension bracket as shown in the figure “Orientation of a cosmetic filler,
a lower door hinge, and a lower left extension bracket” (page 406).
2 Loosely fasten the door hinge through the extension bracket using 4
Pozidriv 12-mm screws P0600060 each with a lock washer P0600895.
Drive the screws from the direction shown in the figure.
3 Tighten all screws to snug plus a 1/4 turn.