Nortel Passport 15000, Hardware Installation And Maintenance, Page: 360 / 874

360 Chapter 17 Hardware procedures
241-1501-240 5.2S2
the lower pair, and there is a pair at the front and rear where the frames
are joined.
4 From NTRU0365, align an L-shaped bracket (part number P902817) on
the middle upper left front according to the figure (long arm outwards).
5 Fasten the bracket to the frame using the 4 thread-forming 6-mm (1/4-in.)
screws provided. Ensure the screws are fully seated perpendicularly to
the hole before turning. Tighten to snug plus a 1/5 turn.
6 Repeat step 4 and step 5 for the upper right bracket.
7 From NTHR0370, place the U-shaped bracket (part number P0902826)
over the arm created from the left and right brackets. Fasten it to both
frames using the 4 provided screws and washers. You may need to
temporarily shim some frame feet to align both the left and right bracket
holes.
8 From NTRU0365, align an L-shaped bracket (part number P902817) on
the middle upper right front according to the figure (long arm outwards).
9 Fasten the bracket to the frame using 4 screws and washers.
10 Repeat step 8 and step 9 for the lower right bracket.
11 From NTHR0370, place the U-shaped bracket (part number P0902826)
over the arm created from the left and right brackets. Fasten it to both
frames using the 4 screws and washers. You may need to temporarily
shim some frame feet to align both the left and right bracket holes.
12 Repeat step 4 to step 11 for the upper and lower rear joining brackets.
13 Remove any shims under the frame feet that were used to align bracket
holes for fastening.