SS300 Service Information (3-2017)
81
SERVICE
ON-BOARD BATTERY CHARGER
Pro/Membrane Models - Service application software
required, contact service. As an alternative, the char-
ger profile may be manually changed. See CHANG-
ING ON- BOARD BATTERY CHARGER SETTINGS
for Pro-Membrane model. The battery discharge in-
dicator will automatically reprogram to match battery
type when the battery charger profile is changed.
Pro-Panel Model - See CHANGING ON-BOARD
BATTERY CHARGER SETTINGS for Pro- Panel
model. The battery discharge indicator will automati-
cally reprogram to match battery selection.
CHANGING ON-BOARD BATTERY CHARGER
SETTINGS (Pro-Membrane model)
To manually change the on-board battery charger
settings for a different battery type, carefully follow
instructions as described below :
NOTE: The manual method is only an alternative
if unable to change setting by use of the Service
Application Software performed by Service.
1. Disconnect battery cables (Fig. 114).
Fig. 114
2. Unwrap the battery charger power cord from the
cord hooks.
3. 3. Using a T25 star screwdriver, remove the
two screws located at the bottom of the control
console to access battery charger (Fig. 115).
Fig. 115
4. Disconnect the battery cable, power cord and
wire harness from charger. Using a T25 star
screwdriver, remove the four screws that mount
charger to machine (Fig. 116). Remove charger
from machine.
Fig. 116
5. Remove the black cap from bottom side of
charger to access the profile dial (Fig. 117)
Fig. 117
6. Using a small standard screwdriver, turn the dial
to the appropriate battery type according to the
following chart (Fig. 118).
