102
SS300 Service Information (3-2017)
SERVICE
5. Remove battery charger mounting torx hardware
(4).
6. Remove battery charger.
INSTALLING ONBOARD BATTERY CHARGER
FOR SAFETY: When servicing machine,
disconnect battery connections before working
on machine.
1. Installation is reverse of removal.
NOTE: This battery charger can be programmed for
multiple battery configurations. This configuration
data is stored in the interface module and will
automatically configure a replacement battery
charger once installed and following a power-up
cycle. Reprogramming is required if the interface
module has been replaced, or if a different type
of battery is used in the equipment (i.e. other
than factory-installed equipment). (See SERVICE
DIAGNOSTICS TOOL in the SERVICE section of this
manual)
Models equipped with the PRO-Panel LCD Touch
Panel can be configured through the touch panel.
All other models must be configured using separate
configuration software via a mini-USB programming
port on the back of the operator’s console. (See
SERVICE DIAGNOSTICS TOOL in the SERVICE
section of this manual.)
