Nobeltec InSight Radar 2, Installer'S Manual

Page: 44 / 76

38
Nobeltec InSight Radar (IR2)
Installer’s Guide
Connecting IR2 to an existing network
All computers running Windows assumes the existence of a router/hub and is pre-
configured to obtain an IP address automatically. So, unless you have changed this
setting or you followed the instructions above for a direct connection, this setup
process is fairly straightforward.
Step 1: Connecting the devices
Using a patch cable (sold separately), connect the PC and the Control Box to an
appropriate Router/hub. If you are using a high speed wireless card, follow the
manufacturer’s installation procedures to get everything connected and tested
properly.
Patch cables should be as short as possible, but can be up to 200’ if required and
can be purchased from any computer supply store.
CAUTION
PC network installations can be significantly more complicated. Make
sure to verify that the network is properly setup and running, and
that a qualified network administrator is on-board. Other than limited
phone support, Nobeltec is not able to provide support on Network
installation or operation.
CAUTION
Wireless networks function with limited bandwidth and are susceptible
to RF interference. Please check with Nobeltec for tested network
components.
The PC Connection