Nobeltec InSight Radar 2, Installer'S Manual

Page: 56 / 76

50
Nobeltec InSight Radar (IR2)
Installer’s Guide
functions.
The above dialog is used for all preset controls (your actual values may vary from
those in the image). Pressing OK applies and saves the changes you have made.
Pressing Cancel undoes any changes you have made, and restores the settings
prior to modification. Restore Defaults sets the values to factory defaults.
Follow the instructions below to adjust specific preset values on the radar.
Auto Tune Preset Controls
The Nobeltec radar is always in auto tune mode. In order to optimize the image, it
is necessary to set the auto tune preset to make sure you are receiving the best
quality image possible. Once set, you should not need to adjust the auto tune preset
unless the image quality deteriorates out of the control of the auto control. Generally,
you should adjust the auto tune preset once a year to make sure you have the best
image.
Follow these steps:
1) Select Adjust Radar Presets by right clicking on the radar image window or from
the Radar menu.
2) Adjust the auto tune control down until you see the image start to deteriorate.
Note the value of the setting.
3) Adjust the auto tune control up past the point where the image looks good until
the image starts to deteriorate.
4) Select the point between the two where the quality of the image is at its best.
Setting the Auto Gain Preset
The auto gain function automatically preserves the look of the image based on the
auto gain preset. You must first adjust the auto gain preset before adjusting the auto
sea settings. Once the auto gain is set, it will be set for all ranges.
Follow these steps to adjust the Auto Gain preset:
1) Click and depress the Auto Gain toolbar button .
2) To adjust the image quality, right click in the InSight Radar window and select
Adjust Radar Presets
The PC Connection