Instruction manual
OCM Pro CF
®
OCM Pro CF - Rev. 09 as of 07.06.2016
page 153
Parameter Menu (PAR) Part 2
3
only active if "subdivide geometry" = 3
channel profile(s)
area bottom
round pipe
x
3r egg
rectangle
U-profile
trapezoid
2r egg
Q=f(h)
area middle
custom shape
x
height-width
height-area
area top
round pipe
channel dimensions
area bottom
depending on previously selected profile
prompting for r, h/w, r/h, lower/upper w/h
or h/Q
area middle
depending on selection
height-width or height-area table
area top
enter r, total height and
section height
level
sensor type
air-US NIVUS
water-US internal
x
2-wire probe EX
constant level
pressure internal
2-wire probe
4
select layers (only if combination of min. 2 sensors selected)
2
mounting offset (not indicated if 'constant level' or ext. sensor selected)
height h
0
height H
0
height L
2
scale (only at ext.sensors as well as combinations)
offset
0
span
1
delay
18
height (only at 'constant level')
select layers
