Instruction manual
OCM Pro CF
®
OCM Pro CF - Rev. 09 as of 07.06.2016
page 81
Subdivide Geometry
This is a special parameter which enables to easily set parameters for large
special profiles with convex tops. This parameter will not be required for the
very most applications! Mainly, authorised NIVUS personnel is going to use this
function; which nevertheless will be described here briefly.
This parameter allows to subdivide special profiles with convex tops and
possibly with a bottom featuring a dry weather channel into 2 or 3 level / height
zones, which facilitates the programming of the total profile dimensions.
Pressing the >ALT< key will switch between the 3 options described below:
-
NO (no profile subdivision, standard setting)
-
2 (subdivide in 2 level / height zones)
-
3 (subdivide in 3 level / height zones)
Fig. 9-22
Profile divided into 3 zones
Channel Profile(s)
If the profile has not been subdivided first select the zone (bottom, centre, top)
with the >ALT< key and set the desired profile subsequently. You can select
between following standard profiles according to German ATV A110:
(see dimensions to enter in brackets)
-
Pipe
(radius)
-
Egg, h:w = 1,5:1
(radius)
-
Rectangle
(channel height and channel width)
-
U-Profile
(channel height and radius)
-
Trapezoid
(channel height, trapeze width bottom/top, height)
-
custom profile
(spot heights and according channel widths)
-
2r Egg, h:w = 1:1
(radius)
-
Q= f(h)
Fig. 9-23
Channel shape selection
