Instruction manual
OCM Pro CF
page 130
OCM Pro CF - Rev. 09 as of 07.06.2016
®
9.5.12 Parameter Menu "Communication “
Note
Communication can be used only in conjunction with wall mount enclosure
units! Communication can be programmed on a panel mount unit as well, this
transmitter however is not equipped with an Ethernet interface!
Modifications in this menu are required only as long as you wish to access the
unit via Internet or a local network.
Depending on the type of transmitter (see chapter 2.7) communication via local
Intranet, analog modem, ISDN modem or GPRS modem is available. Direct data
exchange via Ethernet / Modbus TCP is possible as well.
If no other NIVUS device has been connected to Internet at the moment of initial
start-up, it is indispensable to have the portal initialised by the NIVUS service.
Due to this reason please complete the >Internet connection< form and return it
to the NIVUS commissioning service in order to prepare the connection setup.
The form can be found in the download area on www.nivus.com. Please fill out
as complete as possible to avoid later requests.
Note
Please fill out the fields marked with * completely. The Internet connection
cannot be set up by NIVUS without these details!
Fig. 9-111 Internet connection options
Remote control
Select from the following options for remote access:
Off
:
no remote access possible
Modem
:
connection via built-in modem
(GPRS, analog or ISDN)
Ethernet
:
communication via local network (Ethernet)
Mod.
à
Eth.
the unit is going to be called/enabled via the built-in modem.
The following communication will be performed via local network
such as WLAN and/or Ethernet
Any variation is possible to be chosen theoretically. In practical use however it is
possible to use only options the unit has been equipped with. The respective
configuration is indicated by the device ID which can be found on the unit
(see also chapter 2.7)
