Nitsuko NVM-2e, Installation Instructions Manual

Page: 5 / 53

NVM-2ex Installation Instructions and Software Release Notes
Issue 1-0 1
About NVM-2e
Your NVM-2e generally operates and is programmed as described in
the NVM-2 Setup Guide (P/N 17690SET02 or higher), NVM-2
Programming Guide (P/N 17690INS02 or higher) and NVM-2 Release
Notes for Version 1.05.07 (P/N 17690UPG01 or higher).
The NVM-2e cabinet is different from the NVM-2. (The NVM-2 is
the unit shown in the documentation mentioned above.) See Figures 1
and 2 for different views of the NVM-2e.
NVM-2e is flash-RAM based. Batteries are not required to back up
system memory.
Note:
You should ignore the battery installation instructions in the
NVM-2 documentation.
NVM-2e is available as a 2 port, 3 hour unit (P/N 17780-2P) or as a 4
port, 3 hour unit (P/N 17780-4P). NVM-2e has all of the features of an
NVM-2 as well as all of the changes and enhancements described in
this supplement.
Figure 1: NVM-2e (Back Panel)
Note:
The LEDs are lit when:
the unit has power (Power LED)
the Voice Mail is up and running (Voice Mail LED).
A particular port is busy (Port Status LEDs).
Figure 2: NVM-2e (Front Panel)