Nitsuko NVM-2e, Installation Instructions Manual

Page: 33 / 53

Release Notes for Software Version 1.08
Issue 1-0 29
Changes and Additions in the System Configuration Management
Program (cont’d)
System Options (cont’d)
¾ ¾ ¾ ¾
Lamp Off string (up to 20 digits, N-none) (cont’d)
Every 15 minutes the Voice Mail performs a check on all
Subscriber Mailboxes to see if they have new messages. If not, the
Voice Mail turns off the lamp.
Some phone systems do not allow for multiple lamping to occur.
An “H” in this string indicates that after checking a Subscriber
Mailbox and finding no new messages, the Voice Mail will go off
hook, dial the lamp on string, and then hang up. The Voice Mail
then proceeds to the next Mailbox to perform the check.
D
EFAULT
:
Depends on the phone system that is installed.
E
NTRIES
: Up to 20 digits, N-None
Special Codes:
F - flash
P - pause
M -
Monitor pause
X - extension
W - wait for dial tone
G - number of messages
A - analyzed pause
S - Wait for sound
H -
Hang up (If you use the “H,” be sure to place the “H”
at the end of the string.)
¾ ¾ ¾ ¾
Silence limit during recording (secs)
(New field)
This is the amount of silence that may be present in a recording. The
silence is measured in seconds.
If the silence is greater than the value for this field, the Voice Mail
erases the remaining silence as long as the field Eliminate silence
during recording is enabled.
D
EFAULT
: 5 (seconds)
E
NTRIES
: 1 - 25 (seconds)
¾ ¾ ¾ ¾
Eliminate silence during recording?
(New field)
Callers may record silence at the end of a message they are recording.
This option allows the Voice Mail to erase (eliminate) this silence.
D
EFAULT
:
N
E
NTRIES
: Y (yes)
N (No)