Nitsuko NVM-2e, Installation Instructions Manual

Page: 15 / 53

NVM-2e Installation Instructions
Issue 1-0 11
Connect a Phone System to NVM-2e
You can connect a Portrait, 28i, 124i, Onyx VS or Businesscom DS01
phone system to the NVM-2e. For specific equipment that you need
for each phone system, see the NVM-2 Setup Guide (P/N 17690SET02
or higher).
To connect a Portrait phone system to the NVM-2e:
1.
Plug one end of a modular line cord into Port 1 on NVM-2e. Plug
the other end into an RF14 to RJ11 adapter or RJ14 jack. See
Figure 6.
2.
Using a 4-wire modular line cord, connect the adapter into a Voice
Mail Interface Unit. The line cord’s RD/GR pair corresponds to
Port 1 on the Voice Mail.
3. Using another 4-wire modular line cord, connect L1 on the Voice
Mail Interface Unit to a Station Port on the Portrait. (Be sure to
connect L1 to the Station Port based on the Portrait Setup you
have. See the Portrait Phone System Requirements in the NVM-2
Setup Guide.)
4. Repeat steps 1 through 3 for Port 2 using Figure 6 as a guide.
5.
If your Voice Mail contains Ports 3 and 4, repeat steps 1 through 4
using a second Voice Mail Interface Unit.
Note:
Extensions will receive notification of new messages
(blinking Message Waiting lights and interrupted dial tone
for single line phones) only if Port 2 is connected to the
phone system.
1 2
24 VAC
0.7A 50-60Hz
IOIOI
NVM2exVB-C4
AC Adapter
AC Power Cord
Port 2 Port 4 Port 1 Port 3
RJ14 to RJ11 Adapter or RJ14 Jack
To Portrait Station Port
L1
L2
To Portrait Station Port
Voice Mail Interface
VOICE
MAIL
INTERFACE
LINE 2 LINE 1
L2 or BK/Y1 pair L1 or RD/GR pair
(
connects to lower-numbered
port in connector
)
Figure 6: Connecting the NVM-2e to the Portrait