Nitsuko NVM-2e, Installation Instructions Manual

Page: 28 / 53

Release Notes for Software Version 1.08
24 Issue 1-0
Changes and Additions in the System Configuration Management
Program (cont’d)
Changing Ranges of Mailboxes in the Numbering Plan (cont’d)
9. When finished, press Q and then press <Enter>.
10. At the System Configuration Main Menu, press Q then <Enter>.
11.
At the DOS prompt, type VM and press <Enter> to start up the
Voice Mail.
12.
Logon to a System Administrator’s Mailbox, and re-initialize the
Voice Mail Database.
For instructions, see the NVM-2 Programming Guide, Chapter 5.
Example: A sample Mailbox Range Table is shown below
Mailbox Ranges for XX
----------------------------------------------------------------------
Seq. Starting Mailbox Mailbox
# Mailbox # Count Type
----------------------------------------------------------------------
1 ... 10 ... 6 ... Extension
2 ... 20 ... 6 ... Extension
3 ... 30 ... 6 ... Extension
4 ... 71 ... 2 ... Trunk
5 ... ... 0 ... Undef
6 ... ... 0 ... Undef
7 ... ... 0 ... Undef
8 ... ... 0 ... Undef
9 ... ... 0 ... Undef
10 ... ... 0 ... Undef
----------------------------------------------------------------------
P ... Print/display the mailbox range table
E ... Edit a mailbox range by sequence #
C ... Clear a mailbox range by sequence #
Q ... Quit and return to main menu
Explanation:
In this example, the Mailbox/Extension Range consists of 4 sequences.
Each sequence is numbered consecutively and contains the following
entries:
•
Sequence 1 (10 through 15)
A 10 is entered for the Starting Mailbox #. Since there are a total
of 6 mailboxes in this sequence, a 6 is entered for the Mailbox
Count. Because they are all Subscriber Mailboxes, the entry is
Extension for the Mailbox Type.
•
Sequence 2 (20 through 25)
A 20 is entered as the Starting Mailbox #. Since there are a total
of 6 mailboxes in this sequence, a 6 is entered for the Mailbox
Count. Because they are all Subscriber Mailboxes, the entry is
Extension for the Mailbox Type.
•
Sequence 3 (30 through 35)
A 30 is entered for the Starting Mailbox #. Since there are a total
of 6 mailboxes in this sequence, a 6 is entered for the Mailbox
Count. Because they are all Subscriber Mailboxes, the entry is
Extension for the Mailbox Type.
•
Sequence 4 (71 and 72)
A 71 is entered for the Starting Mailbox #. Since there are only
two mailboxes in this sequence, a 2 is entered for the Mailbox
Count. Because they are both Trunk Mailboxes, the entry is
Trunk for the Mailbox Type.