Nilfisk-Advance CS7000 Fuel Cell EcoFlex, Service Manual

Page: 67 / 440

Control System 67 Service Manual – CS7000
• 7 Reduced Speed Mode - The CS7000 can be programmed to automatically limit the maximum travel
speed while scrubbing only, either scrubbing or sweeping, or always.
– When Scrub - The maximum travel speed will be reduced while scrubbing.
– When Scrub&Sweep - The maximum travel speed will be reduced when scrubbing or sweeping.
– Always – The maximum speed is the Scrubbing speed setting.
• 8 Engine Idle Delay - This setting adjusts how many seconds to delay before returning the engine RPM to
idle after the machine stops moving.
• idle.
– RANGE: 10 – 250 seconds
– INCREMENT: 1 second
– DEFAULT: 20 seconds
• 9 Back-up Alarm
– 1 Off - never on
– 2 Reverse Only - Only on in reverse
– 3 Fwd & Reverse - on when in motion
– 4 Fwd, Rev & Hopper - on when motion or the hopper is lifted
• 10 Headlights
– 1 Normal - User controls with key switch (DEFAULT)
– 2 Always On - On when machine is running. Key switch allow momentary off.
• 11 Broom Lift in Rev
– 1 No
– 2 Yes
• 12 Maximum Speed
– RANGE: 20% - 100%
– INCREMENT: 20%
– DEFAULT: 100%
• 13 Fuel Tank Option - This affects the accuracy of the fuel level gauge on models with either a Diesel or a
Petrol (gasoline) engine. The tank size was reduced with the introduction of the gasoline engine and the
diesel engine model also began using the smaller tank size. “New” tanks are 10.2 inches (26 cm) high and
“Old” tanks are 11 inches (28 cm) high. Select the setting that matches the tank size.
– 56511235 New
– 56510433 Old