Nilfisk-Advance CS7000 Fuel Cell EcoFlex, Service Manual

Page: 340 / 440

Solution System 340 Service Manual – CS7000
To Remove and Reinstall the Solution Solenoid Valve
Service Note: You can remove and the reinstall the solution solenoid valve with the scrub deck
either in or out of the machine.
1. Empty and remove the recovery tank from the machine.
2. Remove the scrub deck from the machine (if desired). (Refer to the Scrub System section.)
3. Disconnect the
Electrical Connector
on the
Solution Solenoid Valve
from
the adjacent wiring harness. Note
that you may need to cut the wire tie
holding the
Solution Solenoid Valve
wires to the
Solution Manifold
.
4. Loosen the
Hose Clamp
holding the
Solution Solenoid Valve
to the
Solution
Manifold
.
5. Remove the two
Hex Head Screws
holding the
Solution Solenoid Valve
to the deck assembly and remove
the
Solution Solenoid Valve
from the
machine.
6. Reinstall the
Solution Solenoid Valve
following the above steps in reverse
order.
To Remove and Reinstall a Detergent Pump (EcoFlex™ Models Only)
1. Lift up the Operator seat and engage
the
Seat Prop Rod
.
2. Remove the detergent bottles.
3. Remove the two
Screws
holding the
Cover Weldment
and remove the
Cover
Weldment
.
Hose
Clamp
Hex Head
Screw (2)
Solution
Solenoid
Valve
Electrical
Connector
Solution
Manifold
Seat
Prop
Rod
Screw (2)
Cover
Weldment