Nilfisk-Advance CS7000 Fuel Cell EcoFlex, Service Manual

Page: 316 / 440

Scrub System 316 Service Manual – CS7000
d. Carefully install a new
Gasket
between the
Frame
and the
End Casting
. Make sure the
Gasket
is
seated flat on the mating surfaces.
e. Once the
Gasket
is installed, fully seat the
End
Casting
onto the
Frame
.
f. Tighten the hex nuts.
13. Reinstall the terminals and top terminal nuts, then
reinstall the terminal cover and acorn nuts.
14. Seal the retaining wire holes in the end cover with
silicone sealant.
Specifications
Component Specifications
Scrub Brush Motors (all) 35 VDC, 1 HP, 2750 RPM, 26 Amp
Scrub Brush Motor -
Center
Current Draw (shop
measurements)
Average - 19 Amps Max. - 37 Amps
Scrub Brush Motor - Left
Current Draw (shop
measurements)
Average - 17 Amps Max. - 23 Amps
Scrub Brush Motor - Right
Current Draw (shop
measurements)
Average - 17 Amps Max. - 26 Amps
Deck Actuator Motor
Input Voltage - 34-40 VDC
Dynamic Load - 500 lbs. max.
Static Load - 1000 lbs. max.
Restraining Torque - 100 in.-lbs. min.
Current Draw
9 Amps max at rated dynamic load
2-5 Amps Typical
End of Stroke - Ball detent clutch with a load rating between 600 and 1000
lbs.; will ratchet at end of stroke
Thermal Protection - Automatic resetting thermal breaker enclosed in motor
housing.
Wiring Polarity:
• To extend actuator, connect red lead to positive and yellow lead to
negative.
• To retract actuator, connect yellow lead to positive and red lead to
negative.
Frame
Gasket
End
Casting