Nilfisk-Advance CS7000 Fuel Cell EcoFlex, Service Manual

Page: 309 / 440

Scrub System 309 Service Manual – CS7000
To Remove and Reinstall the Scrub Deck Actuator
1. Remove the recovery tank (refer to the Recovery System section).
2. Turn on the key switch and put the machine into the Service Test mode to allow you to jog the scrub
deck up and down.
3. Extend the scrub deck downward in
the Service Test mode to minimize the
weight on the
Scrub Deck Actuator
.
4. Disconnect the
Scrub Deck Actuator
electrical connector
5. Remove the
Bow-tie Cotter Pin
,
washers and
Clevis Pin
holding the
Scrub Deck Actuator
to the
Deck Lift
Arm Assembly
.
6. Remove the
Bow-tie Cotter Pin
and
Clevis Pin
holding the
Scrub Deck
Actuator
to the machine frame, then
remove the
Scrub Deck Actuator
from
the machine.
7. Reinstall the
Scrub Deck Actuator
by following the above steps in reverse order.
To Remove and Reinstall the Scrub Deck
1. Remove the recovery tank (refer to the
Recovery System
section).
2. Make sure the solution shutoff valve is closed, then disconnect the solution hose to the solution solenoid
valve.
3. Turn on the key switch and put the machine into the Service Mode to allow you to jog the scrub deck up
and down.
Scrub Deck
Actuator
Bow-tie Cotter
Pin (2)
Clevis
Pin (2)
Deck
Lift Arm
Assembly