New lift FST, Manual

Page: 16 / 174

3 FST-Controller user interface
3.1 LC-Display and messages
14
FST_HB.EN04/03
Line C
Status messages in line C Line C is divided and displays one of the following status messages in the
left and in the right part. For scrolling the status messages in the left part
use the key combination
S
+
¤
and for the right part the key combination
S
+
¥
.
The door positions marked with
A
also apply to doors
B
and
C
.
Status Display Description
Car doors
<A>
Door A completely open
>A<
Door A closed
<-A->
Door A is opening
->A<-
Door A is closing
<A*>
Photocell or reversing contact door A
active
<AX>
Door A is locked (test menu)
<AL>
Door is in loading mode (loading
button has been pressed)
-A-
Door A is stopped
?A?
State of door A is unknown (check
door limit switches)
<<>>
Door open button active
<><>
Door close button active
Shaft positioning
Z
Zone message active
F
Zone message missing
-
Car is in levelled position
###@###
Car position relative to levelled
position (each pixel = 2.5 mm)
ö
Correction switch bottom active
ä
Correction switch top active
Car position
P=6200
Current position of the car relative to
levelling position of lowest landing in
[mm]
Levelling
Pd= 02
Current position of the car relative to
closest levelling position in [mm]
Car speed
V=1300
Current speed of the car in [mm/s]
Set / current speed
@######V2
Comparison between set and actual
speed of the car. The left bar is a
graphic display of the relation
between actual speed and the set
speed on the right.
Motor-Hours
BS=4351
Operating hours of the drive
Drive counter
FZ=123456
Number of completed drives
Memory occupied
Rec: 45%
Memory occupied on the PC-Card
when recording.