New lift FST, Manual

Page: 156 / 174

6 Error List
6.4 Error messages
154
FST_HB.EN04/03
11 DOOR OPEN FAILED
Car door does not open.
Infobyte2:
Safety circuit status:
bit 0 .. 2: not used
bit 3: Emergency stop
bit 4: Door contact C
bit 5: Door contact B
bit 6: Door contact A
bit 7: Locking device
(“0” = interrupted,
“1” = closed)
-
Check door drive
-
Check wiring of safety circuit
-
Check operation of door relays
on FSM
-
Check operation of door limit
switches (+24V must be
supplied to FSM X8.2 and X9.2
to open the doors)!
-
Infobyte2 shows the state of
the safety circuit at the time of
the error message.
12 DOOR CLOSE FAILED
Car door does not close.
Infobyte2:
0 = Door A
1 = Door B
2 = Door C
Infobyte3:
1 = fully open, limit switch OPEN is
active
2 = does not close all the way, limit
switch CLOSED is not active
-
The car door is blocked
mechanically or electrically.
-
Check operation of door relays
on FSM.
-
Check operation of door limit
switches (+24V must be
supplied to FSM X8.4 and X9.4
to close the doors)!
13 DOOR LOCK RETRY CNT
Error during closing of doors.
Infobyte2:
0 = Door A
1 = Door B
2 = Door C
The number of lock attempts is
displayed under
MAIN MENUE _
Doors _ Doors Basic _
Lock fault
.
The shaft door contact (lock)
does not close even after n
attempts.
14 DRM–START PROBLEM
Reset
TEST MENU – Fault
Reset
.
The car does not start moving
even with pre-selection active.
15 DRM–DRIVE MONITOR
Monitoring or drive error.
No movement of the car could be
determined during the drive.
Reset
TEST MENU – Fault
Reset
.
The encoder position does not
change even with pre-selection
active.
-
The encoder is faulty.
-
No electric connection to
encoder.
-
The drive does not move.
Code Message Description Reason