New lift FST, Manual

Page: 30 / 174

3 FST-Controller user interface
3.1 LC-Display and messages
28
FST_HB.EN04/03
Information texts
When triggering actions in the FST Menu information texts may be
displayed. They contain information on the result of the action.
Display Description
*!! EMERGENY MODE !!*
The controller is in emergency operation mode. Drives are not possible.
Emergency operation is activated by pressing the
S
key while switching the
system on.
ADM STUCK :...
The landing call from the specified floor and door side is permanently activated
(is stuck).
ADM unconfigured!
A landing button module connected to the shaft bus is not configured. Inform
your NEW LIFT Hotline!
DRIVE INHIBIT ON!
The drive is locked by the LMS bus. Starting will be delayed until the connected
systems have completed their acceleration phases.
Please wait!
The triggered action has not been completed. Please wait!
FAX\SMS SENT OK!
A status fax has been successfully sent via the modem interface.
FAX\SMS –> GST!
A fax/sms is sent to the group controller where it will be sent via the FAX-
modem.
FAX\SMS NOT SENT!
Transmission of a status fax via the modem interface has been aborted. Check
modem and telephone connection. See
MAIN MENU - Config -
Modem\Fax\LMS
FILE NOT FOUND!
The inserted PC-Card does not contain the files required for the triggered
action.
FST Software Update
The software of the FST is updated with a PC-Card. The progress in [%] is
displayed in line C.
GST UPDATE COMPLETE!
The software update of the GST Group Controller has been completed.
PRIO CAR ACTIVE...
Soft priority car is waiting for standstill after the pending in-car call. See
MAIN
MENUE - Config - Prio-landing\car
.
Calibration abort!
The calibration drive has been aborted. Check function of connected drive
speeds. Locate reason for abortion in the error list.
NO <CT> SIGNAL
The car is on the top floor and the correction top signal is missing (only when
using incremental positioning). Check function of CT switch. Check settings in
MAINMENUE - Positioning - Increm.Pos. - CT\CB-level
.
Check setting of jumper JMP6 on the FST board.
NO <CB> SIGNAL
The car is on the bottom floor and the correction bottom signal is missing (only
when using incremental positioning). Check function of CB switch. Check
settings in
MAINMENUE - Positioning - Increm.Pos. -
CT\CB-level
. Check setting of jumper JMP6 on the FST board.
CONFIG TRANSFER ERR!
An error has occurred during copying of the controller configuration.
CONFIG TRANSFER OK!
Copying the controller configuration has been completed successfully.
CONFIG[D] CORRUPT!
A parameter of the drive configuration is not plausible. Change a parameter in
MAIN MENU - Drive
and undo the change again. The information text
disappears after saving the settings.
CONFIG[S] CORRUPT!
A parameter of the system configuration is not plausible. Change a parameter
in
MAIN MENU - Config
and undo the change again. The information text
disappears after saving the settings.
LEARN DRIVE FAILURE!
The started learn drive has not been successful. Check function of signals zone
B, correction bottom and correction top.