New lift FST, Manual

Page: 124 / 174

1 Menu tree
1.4 MAIN MENU – Config
122
FST_HB.EN04/03
Group Settings –
ADM-Bus Mask-2
Allocation of the FST to the individual bus lines of the group in
simplex mode (“separated group mode”, see GST Manual). 00 ... FF
Anti Nuisance –
Maximum Car Calls
Maximum permitted number of accepted in-car calls. This
parameter helps avoid unnecessary drives caused by in-car
calls. A reasonable number is the maximum number of
passengers. 0 ... 63
Anti Nuisance –
Stops w/o Exit
All in-car calls will be cleared if the photocell does not trigger
for the set number of stops. This parameter helps avoid
unnecessary drives caused by in-car calls. 0 ... 63
Anti Nuisance –
Empty Car Sense
If the input “Empty Car Sense” is activated, no more in-car
calls will be accepted (see “FSM: X11” on page 63). This
parameter helps avoid unnecessary drives caused by in-car
calls. Only activate this function if the weight sensor is
equipped with a “Empty Car Sense” (Level-Empty) contact
and this contact is connected to the FSM! YES
NO
Anti Nuisance –
Call Direction
All in-car calls against the current direction of travel will be
cleared when changing direction (e.g. when reaching a top or
bottom limit. This parameter helps “educate” passengers to
use the two button control correctly. Only activate when using
a two button control! YES
NO
Anti Nuisance –
Always Clear Up/Dn
When approaching the target floor both landing calls (up and
down) will be deleted. This parameter helps avoid
unnecessary drives caused by “double calls” from one
passenger when using a two button control. Only activate
when using a two button control! YES
NO
Car Ventilator –
Control Mode
Control modes for the Car Ventilator (see “Car ventilator” on
page 128). Switched Off
Manual On/Off
Off-Delay
AuOff-Delay
Car Ventilator –
Vent. Off Delay
Run-on time of the car ventilator in modes
Off-
Delay
and
AuOff-Delay
.
0 ... 250 sec
Car Light –
Car Light Off Delay
Automatic deactivation of the car light after each drive after the
set time. 0 ... 250 sec
Car Light –
Monitoring
Monitoring the car light with a current sensor (FSM X14). If this
parameter is activated the function of the car light is monitored
with a current sensor. The system will be shut down with
CAR
LIGHT FAILURE
if the car light fails (see “CAR LIGHT
FAILURE” on page 157).
YES
NO
Car Light –
Evac. – Light Off
Switch off the car light after an evacuation drive. YES
NO
Car-Operate-Panel –
EAZ type
Position indicator code issued by FPM X4.
-
HEX: Binary code
-
1-of-N: Separate signal for each floor (only possible up to a
maximum of eight floors)
-
GRAY: Gray Code
The initial value for the bottom floor can be set in
Bottom
Flr. Car
(see “Bottom Flr. Car” on page 120).
HEX
1-of-N
GRAY
Car-Operate-Panel –
Lamp type
Type of lamp for in-car acknowledgement (important to avoid
flickering). LED
Filamt
Car-Operate-Panel –
Display-0
Function of pin X4.39 on the FPM Car-Operate-Panel. See
“Display-0 … 2” on page 128. 00000000 ....
11111111
Car-Operate-Panel –
Display-1
Function of pin X4.38 on the FPM Car-Operate-Panel. See
“Display-0 … 2” on page 128. 00000000 ....
11111111
Menu item Description Setting range