76
BioFlo/CelliGen 115
y
M1369-0050
User’s Guide
9
9
R
R
E
E
I
I
N
N
S
S
T
T
A
A
L
L
L
L
I
I
N
N
G
G
T
T
H
H
E
E
V
V
E
E
S
S
S
S
E
E
L
L
A
A
S
S
S
S
E
E
M
M
B
B
L
L
Y
Y
9.1
Reinstall the Vessel Assembly
WARNING!
Cold water and hot glass is a potentially dangerous mix! Be sure to let
the vessel cool for a few minutes before reconnecting the water line.
1.
Position the vessel next to the BioFlo/CelliGen 115 control cabinet. Connect the
water lines to the heat exchanger and the exhaust condenser
(see Vessel Assembly
section)
.
2.
Connect the drain line.
3.
Connect the Cooling Loop In and Cooling Loop Return between the cabinet and
the vessel.
4.
Connect Exhaust In and Return between the cabinet and the exhaust condenser (if
present).
5.
Secure all connections.
6.
Connect the Water In to your water supply.
7.
Turn your water utility on to 10 PSIG.
8.
Carefully place the motor on the bearing housing, on top of the vessel assembly.
9.
Remove the pH shorting cap and connect the pH cable to the pH connector on the
control cabinet.
10.
Remove the DO shorting cap and connect the DO cable to the DO connector on the
control cabinet.
11.
Connect the foam probe cable to the foam connector on the control cabinet.
9.2
Load Pump Tubing
The three standard pumps are located on the front of the control cabinet (
see Figure 32):
