45
New Brunswick Scientific
User’s Guide
CAUTION!
Before turning on the main power switch, make sure that:
(1) The input water hose is connected, the drain line is connected and
the water supply is turned on;
(2) The vessel is in place and the quick-connect water lines are
connected to the vessel’s heat exchanger;
(3) The power cord is properly connected to the control cabinet and
plugged into a suitable power outlet.
4.10 Optional
BioCommand Software
If you are using NBS supervisory software, be sure to consult your
BioCommand
user’s manual for installation and start-up instructions in addition to the general
instructions provided below.
A 25-pin RS232/422 “D” connector com port, labeled
SCADA
, is provided on the rear
panel of the control cabinet (
see Figure 17a
) to connect the BioFlo/CelliGen 115 to a
supervisory host computer.
Figure 17a: RS232/422 Interface
SCADA (RS232/422)
connector
