NetComm IAC3000, User Manual

Page: 38 / 226

IAC3000
User Manual
34
y
Select Service Zone Mode : Select a VLAN mode, either Port-Based or Tag-Based .
Note: The switches deployed under IAC3000 in Port-Based mode must be Layer 2 switches only.
The switch deployed under IAC3000 in Tag-Based mode must be a VLAN switch only.
¾
Port-Based: When Port-Based mode is selected; traffic from different virtual Service Zones will be
distinguished by physical LAN ports. Each LAN port can be mapped to a Service Zone in the form of a
many-to-one mapping between ports and Service Zones.
o
Specify a desired Service Zone for each LAN Port: For each LAN port, select a Service Zone to
which the LAN port is to be mapped from the drop-down list box.
By factory default, all LAN ports are mapped to Default Service Zone; therefore, the administrator can
enter the web management interface via any LAN port upon the first power up of the system. From the
drop-down list box, all disabled Service Zones are gray-out; to activate any desired Service Zone,
please configure the desired Service Zone under the Service Zone tab and enable its Service Zone
Status (refer to Section 4.1.7. Service Zones ).