NEC Express5800/120Rj-2, User Manual

Page: 397 / 418

Installing Windows Server 2003 E-9
8.
Select the proper SCSI Adapter and press Enter .
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-116 board is installed.)
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-117 board is installed.)
Continue performing tasks according to the subsequent messages that appear.
9.
When the following message is shown, press
Enter
to start "Welcome to Setup".
IMPORTANT:
If you install Windows Server 2003 on the hard disk
larger than 2,097,152MB(2TB), you can specify only a value equal to
or less than 2,097,152MB as partition size.
10.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has installed: Go on the step 14
– Windows Server 2003 R2 has installed: Go on the step 11
11.
When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be
displayed after logged on to the system.
IMPORTANT:
„
In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
„
You can install Microsoft Windows Server 2003 R2 DISC 2 after
the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2.
In this case, note that the [Windows Setup] screen is not displayed.
12.
Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the optical disk drive.
Confirm the parameters and click [OK].