NEC Express5800/120Rj-2, User Manual

Page: 304 / 418

9-28 Upgrading Your Server
NOTES:
„
Make sure the support arm holds the processor duct firmly (see
figure below).
„
When the support arm comes up, you may lose the screws. Press
firmly the support arm before tightening the screws.
16.
Install the components you removed in steps 1 to 3.
17.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
18.
Run the BIOS SETUP utility and select [Advanced]
→
[Memory Configuration] to verify
that the installed DIMM shows the status "Normal". (See Chapter 4 or details.)
19.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
20.
If the Windows operating system is in use, set the paging file size to the recommended
value (total memory size × 1.5) or a greater value. See Chapter 5 for details.
Processor duct
Support arm