NEC Express5800/120Rj-2, User Manual

Page: 104 / 418

4-14 Configuring Your Server
Option Parameter Description Your Setting
Set User
Password Up to eight
alphanumerics Supervisor password controls access
to the setup utility.
When Enter is pressed, the user is
prompted for a password; press
Esc
to abort. Once set, this can be
disabled by setting it to a null string, or
by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Password on boot [Disabled]
Enabled Disables or enables password entry
on boot.
Fixed disk boot
sector [Normal]
Write Protect Will write protect the boot sector of the
hard drive to prevent viruses from
corrupting the drive under DOS if set
to write protect.
Power Switch
Inhibit
[Disabled]
Enabled
Enables or disables the POWER
switch. If "Enabled" is selected,
power-off with the POWER switch
becomes unavailable after OS boot-
up. (Forced shut down feature is
always acceptable to the server.
Forced shut down is a feature to shut
down by pressing the POWER switch
for at least four seconds.)
[ ]: Factory-set
Security Chip Configuration Submenu
Option Parameter Description Your Setting
TPM Support [Disabled]
Enabled Disables or enables TPM feature.
Current TPM
State – Displays the current TPM state.
Change TPM
State [No Change]
Enable & Activate
Deactivate & Disable
Clear Changes TPM state.
[ ]: Factory-set