MR ETOS TD, Operating Instructions Manual

Page: 92 / 356

9 Visualization
Maschinenfabrik Reinhausen GmbH 2020 92 4453918/14 EN ETOS
®
TD
Reference time
You can use this parameter to set which time is to be transmitted by the con-
trol system. The device uses this information for time synchronization
[
► Section 9.5, Page 83]. You can select the following options:
Option Description
Local The control system transmits the local time.
Note: If you use this option, you must deactivate the au-
tomatic changeover between daylight saving time and
standard time [
► Page 84]. Otherwise the device will use
an incorrect time.
UTC The control system transmits the time as UTC. The de-
vice calculates the local time from UTC and the set time
zone [
► Page 84].
Table 24: Reference time
9.7.3 Configuring IEC 60870-5-103 (optional)
If you want to use the IEC 60870-5-103 control system protocol, you must
set the following parameters.
Settings Parameters IEC 60870-5-103
Name Value
Serial interface RS232
Baud rate 9600
ASDU address 1
Number of databits 8
Parity Even
Number of stop bits 1
DFC compatibility Standard
Reference time UTC
Home
Events
Information
Recorder
Settings
EN CHANGE REBOOT admin 31.01.2020 13:05
Figure 66: IEC 60870-5-103
1. Go to Settings > Parameters > System > IEC 60870-5-103 .
2. Select the desired parameter.
3. Set the parameter.
4. Press the Accept button to save the modified parameter.
Serial interface
You can use this parameter to select the serial interface for data transmis-
sion. You can select the following options:
▪ RS232
▪ RS485