MR ETOS TD, Operating Instructions Manual

Page: 252 / 356

9 Visualization
Maschinenfabrik Reinhausen GmbH 2020 252 4453918/14 EN ETOS
®
TD
Adding a sensor definition
You have to set the following values to add a sensor:
Value Description
Sensor name Entry field, max. 20 characters
Sensor version Format:
X.Y.Z
(e.g. 1.5.2), used together with the sensor
name to provide unique identification of the sensor in the
sensor management menu.
Sensor manufacturer
(optional) Entry field, max. 15 characters
Data points Configuration of the sensor data points
Table 81: Adding sensors
The operation described below is only possible if you access the visualiza-
tion using a computer. You must also have a Parameterizer or Administrator
user role.
Proceed as follows to add a sensor:
1. Go to Settings > Sensor bus > Sensor editor .
2. Press the New sensor button.
Figure 186: Defining a new sensor
3. Enter the sensor name , sensor version and sensor manufacturer (op-
tional).
4. Press the Accept button to save the settings and configure the data
points.
Configuring data points
You must set the following values to configure a data point:
▪ Type
– IREG: Input register (analog input)