ioLogik E2200 Series
Initial Setup
2-4
Restore Factory Defaults
There are three ways to restore the ioLogik to factory default settings.
1.
Hold the RESET button for 5 seconds.
2.
Right-click on the specifc ioLogik in the ioAdmin utility and select
Reset to Default
.
3.
Select
Load Factory Default
from the web console.
Connecting to ioAdmin via Ethernet
Configuring the Host Computer’s IP Address
1.
For initial configuration, it is strongly recommended to use a direct connection between the ioLogik E2200
device’s RJ45 Ethernet console port and the host computer, rather than remotely over the network.
Connect the ioLogik to the host PC with an Ethernet cable.
2.
Set the host PC’s IP address to
192.168.127.xxx
(where
xxx
can be any number from 001 to 253). In
Windows, you can adjust this setting under
Control Panel
Network and Internet
. The default ioLogik
device settings are:
Default IP Address
Default Netmask
Default Gateway
192.168.127.254
255.255.255.0
None
Example IP address:
192.168.127.200
Summary of Contents for ioLogik E2210
Page 138: ...ioLogik E2200 Series Cable Wiring D 4 Digital Output Sink Type...
Page 139: ...ioLogik E2200 Series Cable Wiring D 5 RTD Input Wiring Structure 2 wire 3 wire...
Page 140: ...ioLogik E2200 Series Cable Wiring D 6 Thermocouple Input Wiring Structure 2 wire...
Page 144: ...ioLogik E2200 Series Input and Output Terminal E 4 ioLogik E2262 I O left to right...