Motorola PMP 320, Hardware Installation

Page: 96 / 146

5-12 PMP320HDW2v1
Preliminary
JUL 2010
Connecting the CSM to the Ethernet cable, Earth Ground, the Surge Suppressor Chapter 5: CSM Hardware Installation
Connecting the CSM to the Ethernet cable, Earth
Ground, the Surge Suppressor
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Ethernet Cable Assembly
Before installing the CSM Ethernet cable, ensure that the Ethernet cable is constructed with the
weather protection kit that is contained with the CSM device. Use
Figure 6-6 to construct the
weather protection housing around the Ethernet cable and RJ-45 plug. This weatherized cable
connects to the ENET connector of the CSM.
Figure 5-4 Ethernet cable weather protection assembly
1 Strip cable
sheath.
2 Insert the screw nut into
the
housing.
3 Insert the seal at the back
end of the housing.
7.7
Recommended wire Gauge: 24AWG Screw Nut
Seal
4 Insert the cable all the
way
through.
Cable
5 Crimp the RJ45 plug.
Crimp the
RJ45 plug
6 Insert the plug into the
housing. Then secure the
sealing nut in place.
Plug
7 Strick the gasket on
the
front end of the housing.
Seal
Parts Identification
RJ45 Plug
Gasket
Screw Nut Screw Nut Housing Gasket
Perform the following procedure to connect the Ethernet/power cable to the CSM.