Motorola PMP 320, Hardware Installation

Page: 115 / 146

PMP320HDW2v1 6-13
Preliminary
JUL 2010
PMP 320 Hardware Installation Connecting the CSM to the Ethernet cable, Earth Ground, the Surge Suppressor
Connecting the CSM to the Ethernet cable, Earth
Ground, the Surge Suppressor
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Ethernet Cable Assembly
Before installing the CSM Ethernet cable, ensure that the Ethernet cable is constructed with the
weather protection kit that is contained with the CSM device. Use
Figure 6-6 to construct the
weather protection housing around the Ethernet cable and RJ-45 plug. This weatherized cable
connects to the ENET connector of the CSM.
Figure 6-6 Ethernet cable weather protection assembly
1 Strip cable
sheath.
2 Insert the screw nut into
the
housing.
3 Insert the seal at the back
end of the housing.
7.7
Recommended wire Gauge: 24AWG Screw Nut
Seal
4 Insert the cable all the
way
through.
Cable
5 Crimp the RJ45 plug.
Crimp the
RJ45 plug
6 Insert the plug into the
housing. Then secure the
sealing nut in place.
Plug
7 Strick the gasket on
the
front end of the housing.
Seal
Parts Identification
RJ45 Plug
Gasket
Screw Nut Screw Nut Housing Gasket
Perform the following procedure to connect the Ethernet/power cable to the CSM.