Motorola PMP 320, Hardware Installation

Page: 64 / 146

3-34 PMP320HDW2v1
Preliminary
JUL 2010
PMP 320 Hardware Installation Surge Suppressors
Surge Suppressors
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
The outdoor mounting of the CMM4 requires the 600SSD, 200SSB, and in certain cases the
LCOM surge suppressor. The L-COM surge suppressor is used only if the Gigabit Ethernet port
is being used on the CMM4 switch. The L-COM surge suppressor can be installed in the CMM4
unit. The overall installation instructions are as follows:
•
ground the 600SSD and the 200SSB to Earth Ground
•
connect the protected side of the 200SSB to the AC power supply SGPN4076
•
connect the protected side of the 600SSD to the network switch or router in the
communications hut.
•
add drip loops at any point in the cabling where the cable changes direction.
NOTE
Additional L-COM considerations during installation: if the CMM4 unit is mounted on
the antenna and is located more that three feet away from the communications hut,
an additional L-COM surge suppressor must be installed.
Figure 3-2 600SSD surge suppressor connectors
Surge Suppressor
All cables must exit
through the allocated slots
600SSD and 200SSB Surge Suppressor installation
Use the following procedure to install the 600SSD and the 200SB surge suppressors.