Motorola PMP 320, Hardware Installation

Page: 71 / 146

PMP320HDW2v1 3-41
Preliminary
JUL 2010
PWR GN
D
1 3 5 7 9 11
2 4 6 8 10 12
13 14
POWER DEF
AUL
T
GPS_M ET
HERNET
PWR
ACT
IV
IT
Y
L
INK
SYNC
O
K
ET
GPS
SWITCH
2 4 6 8
4 6 8
3 5 7
3 5 7
Cabling a CMM4 Chapter 3: CMM4 Hardware Installation
Cabling a CMM4
Figure 3-5 CMM4 connection diagram located on the door of the unit
TOTAL 20 VDC
ACCESSORY POWER
IS NOT TO EXCEED
20 WATTS.
ACCESSORY POWER
OUTPUTS
+20 V +20 V
Twist wire pair 1 twist per inch and
form three loops around ferrite core
for RF emission compliance.
Short wire to ChassisGround
at Switch mounting screw
for RF emission compliance.
Green
Black Red
EtherWAN Switch
( Power Port View )
NOTE:
Refer to the System User Guide for
the power requirement of the switch
OUTPUT OUTPUT
specific to the switch part number.
GND (Black)
REDUNDANT
+V (Red)
+29 V
REDUNDANT
+29 V +56 V +56 V
INPUT INPUT INPUT INPUT
GND GND +V GND GND +V
+V GND
+V
GND +V GND +V GND PE
CMM4 CONTROLLER ( Power Port View )
EXTERNAL
PROTECTIVE EARTH
GROUND
+29 V +56 V
EtherWAN Switch
OUTPUT
Red
OUTPUT
Green
RS232
( Ethernet Port View )
OR
Red Green
+29 V +56 V
1000 BaseT 1000 BaseT
DEFAULT
NORMAL
OUTPUT OUTPUT
AUX SYNC ETHERN
TOGGLE
SHIELDED ETHERNET CABLES
LEDs
N Connector
INTERNAL
GPS CABLE
CMM4 CONTROLLER ( Ethernet Port View )
MAC ADDRESS IP ADDRESS
TO GPS ANTENNA
CAUTION:
Damage my result if non-approved
equipment is connected to powered parts.
IMPORTANT
See the System User Guide before connecting
to power. The Guide is available on-line at
http://motorola.wirelessbroadbandsupport.com/software/
www.motorola.com
P/N: 5487639D03
CMM4 CONTROLLER
PORT 1
PORT 2
PORT 3
PORT 4
PORT 5
PORT 6
PORT 7
PORT 8
PORT 9
PORT 10
PORT 11
PORT 12
PORT 13
PORT 14