Motorola PMP 320, Hardware Installation

Page: 94 / 146

5-10 PMP320HDW2v1
Preliminary
JUL 2010
1 Temporarily apply power to the CSM to adjust the CSM for signal strength.
NOTE
Do not connect to the consumer computer at this time.
The AC line cord is not provided with the hardware. Acquire the
appropriate power line cord for the country where the unit is installed.
2
Connect an Ethernet cable to the CSM and to a laptop.
3
Log into the CSM GUI application to view the status of the signal strength of the
CSM unit. Enter the following default user name and password IDs:
•
Login ID - operator
•
Password - wimax
4
Aligning the CSM for best signal strength Chapter 5: CSM Hardware Installation
Aligning the CSM for best signal strength
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
NOTE
This alignment procedure assumes that the installer has reviewed the site
interference values collected for the area of the installation.
The bolts connecting the two pole/wall brackets to the bracket arm are not yet fully tightened.
Hence, use the bracket arm to adjust the vertical and horizontal tilt of the CSM. This adjustment
helps the CSM to obtain the strongest signal from the service provider.
Perform the following procedure to adjust the vertical and horizontal tilts of the CSM.
Procedure 5-6 Adjusting the vertical and horizontal tilt of the CSM for level of
service connection
Adjust the CSM by rotating the CSM to the left and right. Find the position of the
CSM where the CSM GUI indicates the strongest signal strength to the unit. Verify
the signal strength on the status page of the CSM GUI screen.
Continued