Motorola PMP 320, Hardware Installation

Page: 84 / 146

Chapter
5
CSM Hardware Installation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
■
■
This chapter provides the instructions and procedures used to:
•
connect the CSM device to a pole or wall
•
pre-power up alignment for level of service connection
•
cable the unit
•
ground the unit
•
add surge suppression
•
post power up connection
•
IP connectivity alignment correction
CAUTION
The orientation of the CSM when installed is important. The face of the CSM with the
Motorola logo must be pointing in the direction of the antenna facing outwards from
the building. The Ethernet connector must be oriented so it is on the bottom
right corner of the CSM.
Figure 5-1 CSM (CPE) 320 Identification
Canopy CSM 320
Ethernet Connector
Front Rear
PMP320HDW2v1 5-1
JUL 2010
Preliminary