Mitsubishi FX2N-32DP-IF, User Manual

Page: 40 / 198

FX2N-32DP-IF Profibus-DP Interface Unit Wiring 3
3-2
10) The terminal screws of FX
2N
-32DP-IF is M3.5 (0.14"). However, the terminal screws of the
FX
0N
, FX
2N
Series extension I/O units/blocks and special function units/blocks are M3
(0.12"). The crimp style terminal (see drawing) suitable for use with these screws should
be fitted to the cable for wiring.
When installing 1 or 2 crimp terminal to a terminal, see each explanation below. However,
3 crimp terminals or more cannot be installed to a single terminal.
a) Handle the crimp terminal of the following size as and when 1 wire is used per terminal.
Refer to Figure 3.3 for installation instructions.
Figure 3.1: Crimp Terminal for M3.5 Screws
Figure 3.2: Crimp Terminal for M3 Screws
Figure 3.3: Installing 1 wire Per Terminal
b) Handle the crimp terminal of the following size as and when 2 wires are used per
terminal. Refer to Figure 3.6 for installation instructions.
Figure 3.4: Crimp Terminal for M3.5 Screws
Figure 3.5: Crimp Terminal for M3 Screws
Figure 3.6: Installing 2 Wires Per Terminal
6.8 mm (0.27" )
or less
φ
3.7 (0.15")
6.8 mm (0.27")
or less
φ
3.7 (0.15")
6.2 mm (0.24" )
or less
φ
3.2 (0.13")
6.2 mm (0.24")
or less
φ
3.2 (0.13")
Crimp terminal
Terminal
Terminal screw
6.8 mm (0.27" )
or less
φ
3.7 (0.15")
6.8 mm (0.27")
or less
φ
3.7 (0.15")
6.0 (0.24") mm or more 6.0 (0.24") mm or more
6.2 mm (0.24" )
or less
φ
3.2 (0.13")
6.2 mm (0.24")
or less
φ
3.2 (0.13")
6.3 (0.25") mm or more
6.3 (0.25") mm or more
Crimp terminal
Terminal
Terminal screw